WheelchairDriver

sorry for my bad English.
You can find a diagram of this adapter?

What does it do, what is it from?

It's a Hirose connector / adapter from Dynamic .

It's just a straight through adaptor plug.

viewtopic.php?f=2&t=2757&p=45458&hilit=hirose#p45458

this joystick dynamic
how to configure the com port I know I do not have this adapter circuit

You could make the leads but you MUST buy a DWD-OEM-U dongle.

http://www.mobilityscooterpart.com/prod ... php?id=133

Its for programming dx2/rhino controllers.

I have a program and a key.
This adapter is a scheme, it is not just an adapter.

So you believe that there is something extra inside the "adapter" ?

This is what I believe it might be....nothing extra ...just cross over wiring.

compilation pic from the thread that I linked to.

sorry for my english. this PC-COM I know that this adapter has something (scheme). it does not work directly with the joystick.

the reverse side contact there

this way joystick

Those two wires are inside the joystick pod? .... just the black and green?

The Hirose plug is in the black housing?

I use the Google translator, sorry. Connection of such
pc


DWIZ-CABLE



DWIZ-ADAPT



Dynamic Shark

woodygb wrote:Those two wires are inside the joystick pod? .... just the black and green?

The Hirose plug is in the black housing?

not. I showed the reverse side there are 3 adapter tacts

in this thing there is something inside, I do not know

Vitolds wrote:in this thing there is something inside, I do not know

I do not believe that there is anything inside except wires ... just cross over connections.

I need to check again ...you have one of these?

key has

I was given at the time of the adapter I did not disassemble it, he glued. we checked the signals from him in it that is exactly what

This


plugs into joystick



OR to this ....



which plugs into





and then plugs into.



Yes?

you do not understand me
I showed the adapter from both sides
in the adapter has something, it does not work directly with the com port
connects all showed higher
adapter glued, there is no possibility to disassemble. I spoil him, he's not mine.

forget it
I do not need

Vitolds wrote:you do not understand me
I showed the adapter from both sides
in the adapter has something, it does not work directly with the com port
connects all showed higher
adapter glued, there is no possibility to disassemble. I spoil him, he's not mine.

Your right ...I do not understand your problem.


You have a problem with making this DWIZ ADAPTOR work?

That adaptor probably has a diode in it
The controller that it is used to program has a combined TX & RX wire ( pin 4 ) like the Penny and Giles range...




So ...inside the adaptor could be something like this combining the RX and TX .

pic for Penny and Giles.

So ...maybe something like this .

This is what I think might be inside the DWIZ ADAPT.

this scheme does not work.
if you put an adapter that works.
what is the adapter contraption worth

Do not try to unscrew the adapter apart because it will break!
Trust me I know! Fortunately I was able to repair it, but it was a pain in the ass and took me e few hours to do so!
Well the adpter seems to have some circuitry inside with some unknown (no code) IC's a transistor or somthing that looks like it, and a few passive components.
It is NOT just a cross wire connector!
Some magic (electronics) is going on in there.
I am intersted If someone has found a schematic diagram or an equivalent working circuit for this adapter.