The speed button (increase) of my VR2 controller just died. I open the case and didn´t found anything broken or burn. Path and vias in the circuit board of the button and around are not cut.
Can I hard reset this board? Any help?
Regards.
lordk wrote:Hi, a late reply for this topic.
The buttons (the conductive side of the physical button) are ok.
It seems to be a design fault (component failure) as a have a few more boards with the same problem. Although the circuit traces of the buttons have conductivity it seems that in some place is broken. No idea how to fix this, yet.
Users browsing this forum: No registered users and 13 guests