5, a 3-stage charger; with adjustable residual current that trickles to float , and float voltage as well
http://diy.lgm3361.com/zxd2400/3/annex1/1/
default settings of residual current and float volt are 30% and 93% respectively (with MAX cap at bulk charge values).
6, display of present & last session Ah delivered
7, auto shunt down ; when output is lower than user prescribed ampere
Burgerman wrote:
Can it be configured for volts current (CC/CV) as well a choose a low termination/residual current like say 100mA? Before going to float?
If so its the perfect battery charger for gel or AGM.
P.S. Whenever the bulk current setting is altered , this trickle-to-float current will be reset to 30% of bulk
Burgerman wrote:Shirley supplied them.
I suggest you be nice to shirley!
Burgerman wrote:..
This one is small and quiet, so will run a PL8 next to my bed. USB'd to my laptop...
!
The encoding knot is held only with a thin nut in front . Just unscrew it and push the knot back in .
shirley_hkg wrote:
However , I find it enters full throttle a bit too soon , ie the heat sink was only slightly warm at touch .
Will it help by just to wrap a few more layers of tape around the thermal sensor ?
Burgerman wrote:If this can really run at 60v and 50A at this tiny size it is remarkable!
shirley_hkg wrote:shirley_hkg wrote:
However , I find it enters full throttle a bit too soon , ie the heat sink was only slightly warm at touch .
Will it help by just to wrap a few more layers of tape around the thermal sensor ?
Will you consider doing it while changing the outfit . .
Return to Everything Powerchair
Users browsing this forum: No registered users and 26 guests