Burgerman wrote:Tell me. How do you know its programmed to go slower?
Its only going to go at 7 to 8kph or 4.5mph at max speed. That does feel slow.
broken_slinky wrote:Burgerman wrote:Tell me. How do you know its programmed to go slower?
Its only going to go at 7 to 8kph or 4.5mph at max speed. That does feel slow.
I'm assuming it's at its lowest setting because the "speed" indicator LEDs are at the lowest value. Pressing the increase or decrease buttons does nothing. .
rover220 wrote:
you can operate the vsi in 2 modes just like vr2 and rnet.
mode 1 is profiles where each 'speed' light indicates which profile you are in. mode 2 is speed mode where each 'speed' light means the chair will go faster upto its programmed maximum.
you need to plug it in to confirm what its currently set as
Burgerman wrote:Not sure those have inhibits for seating etc, could it be that? An inhibit?
broken_slinky wrote:rover220 wrote:
you can operate the vsi in 2 modes just like vr2 and rnet.
mode 1 is profiles where each 'speed' light indicates which profile you are in. mode 2 is speed mode where each 'speed' light means the chair will go faster upto its programmed maximum.
you need to plug it in to confirm what its currently set as
I'm assuming that the speed profiles cannot be changed by some sequence of button presses or joystick moves? Looks like I'll have to fab a cable and source the software. Thanks for the help!
rover220 wrote:afraid not, it will need programming.
Burgerman wrote:This whole thread shows you how. You need a cable, DIY or from woodygb here, and some easy to find software.
evigh wrote:Ok. So I cannot make it go faster with software. It is limited to 11km/h. Wich is really slow.
I guess i program the cable with right hex code and serialnumber?
if i a Chair comes with tilt as the only power feature - - how hard can it be to swap out the VR2 90A PM etc, and replace with Rnet 120 - i am thinking ahead a bit - since i may end up with the VR2 90A model on my next chair - if i do - i may just leave it alone anyway not to bother - but just to know how easy or hard it will be - then programming the tilt feature etc, till now i never programmed from scratch - just adjusted from a Rnet 120A system already
Return to Everything Powerchair
Users browsing this forum: iainsherriff and 48 guests