Programming leads

[woodygb]

Been a while since ive been on here but thank you for those links woody going to make a cable for the mothers new chair. Any links to the software would be greatly appreciated.

You have a private message.

[bob_viv]

Hi Woody, i purchased an s-drive programming cable from you a while back, which has served me well. I now need to program my latest scooter through the charging port. is it possible that you can give me the pinout for the charge port programming. i.e. connections on the four pin plug that i have go to which pins on the round charging port.
Thanks in advance,
Bob.

[woodygb]

Here you go ....
Are you certain that your new scooter uses an S-Drive?

.

[bob_viv]

Yes, for sure,
Thanks a lot and best regards
Bob.

[DoctorFinlay]

Hi,
I have a Sterling S700 scooter which I bought second hand. How would I go about purchasing leads to program the S Drive unit inside? Any info about software would also be greatly appreciated. Many thanks.

[woodygb]

I can supply you with a lead or it is possible to construct one yourself.

[DoctorFinlay]

I can supply you with a lead or it is possible to construct one yourself.

If you could supply me with a lead that would be great, please let me know how much and how to pay. Thank you.

[Jadams]

Hi Woody,

I bought one of your leads around June of 2021. worked perfectly for my S-Drive conversion on a Sterling diamond mobility scooter, I have recently bought a Drive sport rider with a Rhino2 controller, firstly, could the same lead be used to program? and secondly, I believe I would need the dynamics wizard software to do this, I know there is a "modified" version somewhere, does this negate the need for the dongle?

jeff.

[woodygb]

Hi Jeff,

The S-drive lead is NOT compatible with the Rhino2.

The hacked Wizard software doesn't require a dongle.

[Jadams]

Hi Woody,

Thanks, is it possible to make up the leads and obtain the software?

the delay when starting and acceleration is so poor, it's embarrassing when someone lets you cross and looks like you're taking the mick.

jeff.

[Jadams]

I already have USB to serial adapters and a true COM port available.

jeff

[woodygb]

The parts that you already have will not help.

I can however make you an interface that will do both the S-Drive ( plus VR2 , Vsi ,Pilot+ , Egris and SOLO ) and the Dynamic Rhino2 / Shark...A switch is used to select which make either PGDT or Dynamic .

[Jadams]

What's the cost Please

jeff

[woodygb]

£35 incl postage ...payment once I have one made.

It will however take me a little time to complete one as I do not think that I have all the parts kicking around, so I may need to order some.

[Jadams]

Perfect Woody,

Can we do that then please?

Jeff

[woodygb]

[woodygb]

Perfect Woody,

Can we do that then please?

Jeff

Jeff , I have one ready for you.

[DonQuixoteDeLaManche]

Hello Woody,
I have a very old Roma Sirocco and an even older Pride PD11, both of which are amazingly still working well after all these years!
Both wheelchairs use the same PG Drives Controller.
I made a USB>Molex programming cable many years ago from a diagram you published and that was fine, but unfortunately it has been misplaced and lost.
I no longer have the ability to manufacture another owing to my disabilities and I would be deeply grateful if I was able to purchase a replacement from you.
I am not worried about the cost and can pay you by Direct Bank Transfer or by PayPal as you so prefer.
I still hold the PG Drives software (SK76982/7).
Regards, Simon.

[Burgerman]

You might PM him.