PL8 news

[expresso]

https://www.amazon.com/dp/B008ZNWOYY/re ... tries%2A=0


https://www.amazon.com/dp/B07DYXTX9H/re ... tries%2A=0

[Burgerman]

what is that - is that the BT module to use ?

why does it have two wires instead of 3 like the charger has on its module ?

what else is needed -

I explained exactly what it is and does in the post directly above!

You want the one with the ferrite ring to help remove noise.

[expresso]

its not clear enough - there are 3 wires on the PL 8 - there are 2 on this one

either way - it would plug in as the original on the outside - then inside - you have 2 wires also

where do those get connected inside


once thats done - thats it - turn it on and it works - find it pair it and done ?

do i have to remove any wires inside the charger before connecting the new wires ?


is there any better ones than the one i found or is that good - thats the BT module ?

[Burgerman]

You connect the 24V end to the board were the power supply provides 24V to the charger.
You connect the 5V end to the BT board you already have to POWER IT.
You then connect the signal wire and the power wire from your BT board only to the 3 pin connector. And thats it.

[expresso]

i am not going to use the BT i have external - i am leaving that alone -


so i need a BT module also ? which one that you know works

i will wait for detail pics showing the spots i need to connect

no rush -