Help programing a Rhino2 controller

Power wheelchair board for REAL info!

POWERCHAIR MENU! www.wheelchairdriver.com/powerchair-stuff.htm

Help programing a Rhino2 controller

Postby MXDrew » 09 Jun 2021, 08:17

Hi all,
I hope this is ok but I'm not a wheelchair user but a builder of a Toylander which I intend to use the motor, controller etc from FreeRider Mayfair 8.
I'm looking for help with programing the controller, a Dynamic Controls Rhino2. I need to program it to use a single throttle pot and not the Wig Wag and seperate speed limiting pot.
I have downloaded the Wizard 6 program from Dynamic Controls but this needs a dongle at vast expense.
Any ideas?
MXDrew
 
Posts: 9
Joined: 09 Jun 2021, 08:05

Re: Help programing a Rhino2 controller

Postby MXDrew » 09 Jun 2021, 11:32

Reading through the forum I have found most of the information I need but can one of you kind guys pm me the link so I can download the cracked Wizard software?
MXDrew
 
Posts: 9
Joined: 09 Jun 2021, 08:05

Re: Help programing a Rhino2 controller

Postby Burgerman » 09 Jun 2021, 11:38

Check PM
User avatar
Burgerman
Site Admin
 
Posts: 65050
Joined: 27 May 2008, 21:24
Location: United Kingdom

Re: Help programing a Rhino2 controller

Postby MXDrew » 04 Jul 2021, 22:16

Update, managed to program the DS90 controller, main change was to remove wig-wag and have a single ended pot with a direction switch. All worked well then controller has been disconnected from the batteries for two or three weeks while the build is completed. On powering the controller up the program has reverted to use a wig-wag.
Anyone have the answer?
MXDrew
 
Posts: 9
Joined: 09 Jun 2021, 08:05


Return to Everything Powerchair

Who is online

Users browsing this forum: Gregg and 32 guests

 

  eXTReMe Tracker