Quickie 700 lights

[Scragger7]

Anyone know if the led is replaceable and where to they can be bought? Already have a set stop working which were replaced under warranty but have hit one on side of bed and its now not working.

.

[Dan]

They are not cheap. I guess they can just be replaced by cheaper and better 24V LED lights? First thing I would do would be check your broken light. Maybe the LED is still working?

[Burgerman]

Smashed is not a warranty thing so you will need to cough up or take apart what you have and figure out whats failed and get on eBay...

[Scragger7]

Smashed is not a warranty thing so you will need to cough up or take apart what you have and figure out whats failed and get on eBay...

Smashed is a bit of exaggeration but did hit side of bed. Unlike the lights i've seen on all the 700R pics ,mine are mounted up front near front caster and unfortunately gets knocked abit.
Will pull apart and if fixable.

[Burgerman]

Move them. As I did on the salsa.

[Scragger7]

Move them. As I did on the salsa.

Won't be any good there unless i want to light up my legs. I don't use centre footplate'. Tho will try move or make a bracket to protect the side of light from getting knocked.

[Scragger7]

Not paying the outrageous price to replace with original light. So im going to replace the headlights with these and remove the front indicators. Question for those in the know, will these be ok to connect directly to the wiring for the existing headlight so i can turn on and off in joystick?



https://www.aliexpress.com/item/3299122 ... 0201%22%7D

PS. Im thinking of adding a 3rd light in the middle under seat would that still be ok or need to wire separately?

[Burgerman]

Sorry, the page you requested can not be found:(

Dont exceed original watt rating. Read the rnet tech manual, and all will be safe.

[Scragger7]

Sorry, the page you requested can not be found:(

Dont exceed original watt rating. Read the rnet tech manual, and all will be safe.

OK thanks BM they are 10watt 12-24v so should be ok. Was worried about adding the 3rd light, if i look in the lights module of the oem programming it says 12v 40w so 3 10 watt leds should be ok im guessing.

PS. This is from r-net manual
Each lighting output is rated at 21W maximum. Use suitably rated wire to each bulb. The output is self-protecting against wiring
and bulb faults and will shut-off if the maximum power rating is exceeded. Likewise, if the output becomes too hot it will shut-off
to prevent permanent damage to itself.

[Burgerman]

Yes, sounds familiar.

[Burgerman]

Wait for the spam link drop sometime after he thinks he has dropped off the radar.

[Scragger7]

I bought those headlights from the link for my motorcycle from Aliexpress, but when I installed them, they didn't work, so I don't trust anymore to buy from this website. Instead, I ordered from Amazon at a slightly higher price, and they worked very well.

Mine still working fine. I put them in the middle of chair just under seat where the curb climber attaches on the 700R as i don't use centre footplate. No more banging lights against doors i swing open.