Permobil M300 progamming files CF00000.R-NET

[brysan]

My laptop got hit by a power surge while writing the programming file into my M300. I lost my r-net files and the M300 upload was not complete. Does anyone have such file to share?

Thx

[Burgerman]

Does this chair work still?

If so take a copy of the settings file from it, and work from that.

[brysan]

It powers up, but won't move and no control of tilt, recline etc

[Burgerman]

Well you should be able to use any settings file from any chair such as my own. BUT its permobil and uses a load of non standard R-Net replacement parts. So that wont work. If noone uploads a settings file, you should be able to call permobil and download your original file if you give them your serial number. Of course that wont do you any good if the issue is with their own in house seating/gyro/stability module/switches etc. And that will need a different bit of permobil software/cable etc.

[johnbae1980]

My laptop got hit by a power surge while writing the programming file into my M300. I lost my r-net files and the M300 upload was not complete. Does anyone have such file to share?

Thx

try this file.
if your m300 has no ESP module, It will works well.
pm me if your m300 has ESP. I'll send you an extra file for esp module.

[Burgerman]

It may work, if all components have suitable firmware versions but with those drive settings it would be completely unusable for me. So those are going to need the walls removing first and then the drive speeds severely changing. Unless permobil is doing something severely different from normal R-Net in the power module.

[Burgerman]

Just realised its an RNSS file and so incomplete. Those settings make little sense because you have a permobil gyro where the real control settings live...

[brysan]

That's not the file I need. I need the CR000000.r-net file.

[Burgerman]

What you actually need is a complete programming file, a .r-net file. That matches your R-Net and permobil made hardware, and firmware versions so that it is compatible with the mixed components on your chair.

If anyone with a similar age M3 and similar spec permobil chair has the full file (not the .rnss part setting overlay file) then it might work/should work.
The SETTINGS themselves may or may not match your needs and will require configuring. That CF00000.R-NET file is just a name. That can be renamed, or it can be modified as far as settings go and still be the CF00000.R-Net file.

If you want the actual file your chair shipped with inc stock settings, you need to get that from permobil by email. I have dOne this with sunrise and invacare many times. They just want a chairs serial number or order no. and will email this to your inbox.

[FelipeOliveira]

That's not the file I need. I need the CR000000.r-net file.

I have some m300 hd recliners. I will send you to check ok?

[FelipeOliveira]

TRY THIS ONE

[brysan]

TRY THIS ONE

Thank your for the file but its different than I have seen b4. When I open the file i get 2 choice. 1 is read only 2 is write directly to r-net. I need to edit.

[brysan]

I got it working. Thx for the help!