Need help with Dynamic 70A (Pride+ Hall instead of pot)

[fabrasil]

Folks, how are you?

Im my country there'sz a big companie that import Pride's scooters. They had a lot of models and all\ways renewing the models.
I had received to fix a pride sc4100 (celebrity x4) that use a dynamic rhino 70 that seens to be rhino 160/rhino 2 but i can't find the correct one.

Only info that i found by a friend were at wheelchair-parts.

The aaccelleration isn't the 5k pot - it use a hall with 5 wires (24v +/- plus 3 wires out put to driver) .

Im looking for tech info about both pieces and where can i buy new ones?


Cheers,
Fabio

[woodygb]

A CTE Throttle ?

[fabrasil]

Yes, CTE Throttle.

Need tech info about it.

Thank yuou

[woodygb]

Not a clue ...

[Yennek]

How sure are you that it actually is a hall based throttle? Could it be a 3-wire pot with a 2-wire neutral safety switch? Have you looked at the Rhino 2 installation manual? Check out the section #3.10.3, and see if what you are seeing matches.

https://www.dynamiccontrols.com/sites/default/files/2018-05/Rhino2-Installation-Manual-Issue-3_0.pdf

[fabrasil]

How sure are you that it actually is a hall based throttle? Could it be a 3-wire pot with a 2-wire neutral safety switch? Have you looked at the Rhino 2 installation manual? Check out the section #3.10.3, and see if what you are seeing matches.

https://www.dynamiccontrols.com/sites/default/files/2018-05/Rhino2-Installation-Manual-Issue-3_0.pdf

Hi!

Sure its not like this one. There's a magnet in it, and two add wires measure same voltage from batteries (there's + and -)

Cheers

[woodygb]

https://www.youtube.com/watch?v=5xv1uAi8Q5M

I would suggest reverting to the standard 5k pot.

[fabrasil]

https://www.youtube.com/watch?v=5xv1uAi8Q5M

I would suggest reverting to the standard 5k pot.

Hi there!

About link, thanks, its already know but i need to know if there is a way to open that module and what kind of hall it uses. . I believe there's too a small pcb to regulate the voltage.

The main problem is that support is different from 5k pot linear. I already did some changes and work out with 5k pot but need to "build" some small pieces to fix it.

Thanks!