WheelchairDriver

Good evening, after a bit of messing I have managed to get registered on the forum.

Interesting reading and I am learning a lot as I browse.

After reading all the posts on cable manufacturing issues I think I will opt for the easy way out and ask if I can buy one ready made and known working? Please PM me on my options.

I have a Salsa M with a VR2 controller that I want to use as a power plant for a project and have some special requirement I will get into later in a proper thread.

I was test driving the Salsa on the road to day and it peaked at 6.5 mph which I thought was good as I was expecting to get only get 4 and a bit mph.

The next thing I need is some software to poke the controller before I start ripping it apart to graft it into my project.

Can you guys help with some suitable software to assist me?

I was going to upload a picture but the 356kb limit stopped me dead, need to adjust the camera pixel count for smaller file size!


John

Hi John,

Welcome aboard! Do you have the programming cable that connects the VR2 to your PC? See PM for software link.

Steve

Hi Steve

Thank you for the welcome.

I do not have a cable, I was hoping I could purchase one from a forum member.

There appears to be a few issues either buying the right cable and getting the correct colour coded wires in the right places.

Happy to pay for a proven cable then its one less unknown at this early stage of the game.

John

See here... viewtopic.php?f=1&t=5488 woodygb provides cables, drop him a PM. Or you can DIY as per this thread... viewtopic.php?f=2&t=2111 Read through first though.

Steve

Hi kkeaa53!
Welcome to the Burgerman's Forum