SOLVED! - the J1 error Invacare Typhoon 2
Posted:
20 Sep 2016, 18:44by elryko1992
if you have someone this error J1 is from the secondary remote joystick from back if the module is set with this remote, don't remove him, only you reprogrammed the module. Thanks!
Re: SOLVED! - the J1 error Invacare Typhoon 2
Posted:
31 May 2023, 19:09by stevelawiw
Hi everybody, I've not been on this site for a while but I've just had an error code I've never seen before 'J1' and I couldn't find anything useful in any Invacare pdfs that I have so I turned to this site which turned up trumps with this short thread so at least I know what is causing it.
I'll get my laptop out with the Wizard software on it to see if I can find a setting to change to stop the error happening, but I've used the same setup for years and never seen this J1 before. The only thing I can think of is the control module and joystick were sent to Dynamic for repair about six months ago and maybe something was changed then, I have no second joystick on my chair so it's puzzleing
Re: SOLVED! - the J1 error Invacare Typhoon 2
Posted:
01 Jun 2023, 06:31by elryko1992
Change a new joystick, this is the problem of “J1” error.
Re: SOLVED! - the J1 error Invacare Typhoon 2
Posted:
03 Jun 2023, 18:19by stevelawiw
Yes you're right! A new joystick solved the problem, the controller is fine.