haha - funny - now that you said that about the M2 screw - i didnt loose the extra one they gave me - but dont know in which box i saved it in now -
i have to look for that one - the M2 on the front of the MB is the only one i installed - didnt loose the screw there -
it took a while for many reasons today - its done - its clean looking inside and out - the tray on top that slides out for the fans or Rad -
that was a pain and to remove the top cover was way too much involved - i never did it - two fans i had 140mm didnt fit on top the way i intended - 120mm would have but i had to remove the whole top cover which was a pain to do - i didnt do it -
i left it alone - one rear fan - one top fan and one front fan - the CPU cooler was in the way of installing 2nd fan up top - unless it went under the top cover - i didnt bother doing it that way - and didnt feel it would work - fans being too close between tray and cover -
its fine this way - all the wiring is nice and clean - i didnt power it on at all yet - either tomorrow or weekend -
i have to sit it on my desk to connect my monitor keyboard mouse - then will power it on and hope it works
this is not something i do often - so takes time - and i am not doing the physical work - my good friend Quickie did it - i was directing it as much as i can -
led lights are done - reset cable done - speaker done - the only thing i didnt connect which i think has to do with the case led lighting -
had two plugs and one power looking one - not sure where they went or how etc, - manual dosnt say - so i dont think my case led lights will work -
dont care if it dosnt - i have my own led strips connected to the MB - so should be fine - unless one of those need to go to the PSU to power it - in that case - nothing will work when i push the power button -
i find out soon - not going crazy over it just yet - if it rains tomorrow - then i stay home to tinker with it - if not i leave it for another day to power it on and hope it boots